Tile Adhesive Tensile Adhesion Strength Tester

Pull-off tester with motorised loading and digital peak display for tensile adhesion strength of tile adhesives, renders and mortar on substrate. Used in construction chemicals QC and site labs.

Specification

A dolly or tile is bonded to a cured adhesive layer and pulled off at a controlled rate while the peak force is recorded. Adhesion in N/mm2 shows bond quality under initial, water immersion, heat and freeze-thaw conditions. It is a routine instrument for tile adhesive and render manufacturers.

Features

• Load capacity 5 kN with peak hold
• Loading rate 250 +/- 50 N/s
• Self-aligning pull head
• Test plates 50 mm square or round dollies
• Ball joint for axial pulling

Technical Specifications

Load range	0 to 5 kN
Resolution	1 N
Load rate	250 +/- 50 N/s
Dolly sizes	50 mm square, 50 mm round
Accuracy	+/- 1 percent of reading
Standards	EN 1348, ISO 13007-2, IS 15477
Power supply	Rechargeable battery or 230 V AC

Standard Accessories

• Pull-off dollies (set of 6)
• Concrete slab substrates
• Aligning bracket